Noble Round Pen

Available in any diameter.... to suit YOUR needs!
60' Round Pen
60' - 5 1/2' High, 6 Rail Round Pen

Noble Round Pens are made with 12' long panels. Bowgates for the Round Pens have a 6'W x 8'H frame and a gate to match the Round Pen Panels. A 9'H Bowgate is available on special request. 6' High, 6 Rail Round Pens are recommended when using sand.

40' - 6' High, 6 Rail Round Pen

(8 1/2" between rails, bottom rail 19 1/2" off ground)
60' - 6' High, 6 Rail Round Pen

60' - 5 1/2' High, 6 Rail Round Pen

(8 1/2" between rails, bottom rail 13 1/2" off ground)
60' - 5 1/2' High, 6 Rail Round Pen

50' - 5' High, 5 Rail Round Pen

(8 1/2" between rails, bottom rail 17 3/4" off ground)
50' - 5' High, 5 Rail Round Pen

40' - 5' High, 4 Rail Round Pen

(12 1/2" between rails, bottom rail 16" off ground)
40' - 5' High, 4 Rail Round Pen

We invite you to compare the following features with any panel and gate on the market. We are confident you will agree that
logo are the "Ultimate in Livestock Fencing".

Noble Panels - Panel Fence Diagram
CAPS: All panels are capped along the top rail. All gates are capped on top and bottom rail. Our weldon caps prevent injury and enhance appearance.
CORNERS: Top corners are squared, not rounded or curved. This eliminates the chance that livestock may hang a leg in between panels where they are joined.
JOINTS: Joints are notched and welded all the way around for maximum strength and a smooth finish. This process eliminates moisture from penetrating rails and causing damage.
UPRIGHTS: Vertical uprights are built out of the same material as the rails - each upright goes clear to the ground for SUPERIOR SUPPORT. Uprights are spaced evenly throughout the panel, never going over 6' without a vertical upright.
CLAMPS: Panels are attached together with a galvanized panel clamp assembly that is included in the price of each panel. This system leaves only a 3/8" gap between panels. The rigidity of this clamp system also will not allow panels to move and rattle or clang when in use like a pin attachment or chain attachment system.
MATERIAL: Constructed of 15 gauge American-Made 1 - 5/8" OD round galvanized steel tubing. Tubing has a .072 wall thickness and a 65,000 lb yield strength. The rust-resistant finish will provide decades of use and retain its decorative silver appearance.

1 - 7/8" OD 15 gauge material available on special request.